ELECTROCOATNG
the different mix percentages to determine application
voltages, film thickness, visual appearance, corrosion
performance and any other relevant physical, chemical or
corrosion characteristics and properties deemed necessary
for the required specification.
Prior to the actual feed-over and conversion, the electrocoat user must develop a strategy for reducing existing
paint bath volume to make room for the minimum starting
percentage of new paint volume needed. This volume
reduction is typically accomplished by controlled draining
of clean or raw UF permeate without making it up with DI
water. Once the volume reduction of the existing bath is
accomplished, the new paint can be added to return the
bath to operating level. Once this is accomplished, the
electrocoat user can start the regular feed-over procedures
to maintain percent solids in the bath.
OVENS & FURNACES
Large-Capacity Walk-In Ovens
Mark Your Calendar
Standard sizes to 786 cu. ft.
Special sizes to your specs
Gas & Electric models
Choice of air flow patterns
Temps to 1200ºF
The Electrocoat Association's ECOAT14 Conference—
the premier event for electrocoaters—will be held
April 22-24, 2014 in Orlando, Florida. Connect with
and support your industry.
electrocoat.org
-
CLINIC
-
It's Time for You to...
www.grievecorp.com 847-546-8225
-
Save Money Improve Efficiency Reduce Operating Costs Lower Utility Bills
-
It's Time for Your New...
-
Thermal Fluid Heater Steam Boiler Medium Temp Process Heaters
Heating Medium: Thermal Fluids
Temp Range: 350° - 650°F
BTUs: 126,000 - 6,250,000
------
Available with:
Expansion Tanks with Level Controls
Distribution/Air Separation Tanks
Air-Cooled 650° Pumps
Custom Skid Mounts
Steam Boilers:
NEVER A COMPROMISE
FOR QUALITY OR SAFETY
Parker Boiler Co.
5930 Bandini Blvd.
Los Angeles, CA 90040
(323) 727-9800
Fax: (323) 722-2848
sales@parkerboiler.com
www.parkerboiler.com
15 to 250 PSI
HP: 1.5 to 150 HP
Available with:
Feed Systems or DA Tanks
Blow Off Tanks
Softeners
Chemical Feed Systems
Custom Skid Mounts
Medium Temp
Process Heaters
Temp Range: 130° - 400°F
BTUs: 300,000 - 6,800,000
Hot Water or Glycol
---
All Units Available with:
Expansion Tanks with Level Controls
Distribution/Air Separation Tanks
Air-Cooled 400° Pumps
Custom Skid Mounts
Natural Gas, #2 Oil, Propane,
Combination Fired, Low NOx,
or Bio Fuel Firing
All Parker Boilers Use a
Flexible Staggered Tube
Design with 8 to 10 Pass Flow
with a 25-Year Guarantee
Against Thermal Shock.
PRODUCTS FINISHING
— pfonline.com
63